Dear Hugo,
Thanks for your immediate reply,
The situation happened as mentioned below in our design data management.
We are about to assemble a Brake assembly in wheel end item. But when we opened the brake assembly(released one) with latest configuration, the constraints were missing(parts were miss placed). Same assembly we opened in As stored condition. It was opened properly.
"I understand that sub parts of an assembly may under go further modifications. In this case there are chances that constraints may get missed out on that assembly, if Iam correct?"
What we did is, we downloaded the brake assembly with As stored condition & down loaded the wheel end item (tried on both latest & As stored) on which the brake should get assembled. But the action was failed due to incompatible version of a part which was used commonly for both assemblies. Version of the common part which was assembled in Brake is “R1.2” & Version of the common part which was assembled in wheel end item is “A.1”. Here the problem araised. Can you please give me suggestion how we can come out of this issue.
The Windchil PDMLink version is 10.1 date code is M020.
Thanks
Regards,
Elangovan.P